 |
Highlighted posts
| 1989 Bronco XLT Brake Issue |
 | 1980 - 1996 Ford Bronco |
UhDabbler said — Hey... me again.... Few weeks ago I replaced my rear drums, shoes, and wheel cylinders. I bled the brakes but didn't drive the truck because I was also doing transmission work. ...
| Starter when hot |
| 80-96 Ford Bronco Tech Support |
captsb890 said — 89 Bronco 351---The starter is new--but when cold it cranks good but the problem is when the engine is hot, driving it around, the starter labors-? Is it the ground wire--solenoid ...
| High End Professional Restoration of '92 Bronco (Los Angeles area) |
| 1980 - 1996 Ford Bronco |
Popoagie6 said — From a distance, wearing no glasses, this looks like my unrestored '95 XL. Close up, not so much. Wow. They put a lot of money into it, and it looks like it could go anywhere you'd ...
| WHAT DID I DO???? Was running great...94 Eddie Bauer 5.0 |
| 80-96 Ford Bronco Tech Support |
killerklown said — After installing NSS truck runs like crap. Fires right up, but if I touch the gas it feels like have the cylinders cut-out, it slowly revs back up and sounds fine. I took pictures ...
| 1989 Bronco XLT 351W Leaky Head Gasket |
| 1980 - 1996 Ford Bronco |
UhDabbler said — Hey Everyone, I brought up an oil leak I noticed that appeared to be coming from my rear main seal a while back, but while I was under there finishing up my transmission fluid ...
| B pillar access from inside? |
| 80-96 Ford Bronco Tech Support |
SoFloBronco said — Let me preface by saying I feel like I am totally spamming this forum! I try to google as many answers as possible and only ask questions I can't find the answer to on the net. ...
| 94 Eddie Bauer Air Cleaner Hardware |
| 80-96 Ford Bronco Tech Support |
killerklown said — Does anyone know the proper size of the 3 screws that hold down the air box? I'm removing an aftermarket filter setup and need to fasten down the OEM box.
| Transmission Identification |
| 1980 - 1996 Ford Bronco |
miesk5 said — Yo K, How about using this until I can track that info down? [image]
| 1994 Eddie Bauer Shift Solenoid Replacement |
| 1980 - 1996 Ford Bronco |
killerklown said — Best place to buy a new shift solenoid? I have a few pins broken in transmission connector. Anyone have luck with refurbished and/or aftermarket?
| No power under load |
| 80-Current Bronco II & Explorer |
miesk5 said — Yo, Try this Self Test for Diagnostic Trouble Codes (DTC)s by my pal, BroncoJoe19 @ Code ReaderEEC AKA PCM, computer stores the Self-Test program in permanent memory. When activated, ...