Highlighted posts
JBrake said — Has anyone else had trouble with a/c resistors blowing. I'm on number 5 in six months
dac122 said — I owned a 2004 Liberty and loved it. I bought it new with a factory installed tow package, and used it for daily driving and towing a 3500 pound boat. I am looking at low mileage ...
808inthe949 said — So I'm thinking about porting my throttle body. Ok so maybe further than thinking about it as I have already got all my tools and stuff ready. Is it recommended that I remove the ...
Justin Holland said — I want to start thinking about installing a locker. Rear and front. Can you confirm this is the correct part for either front or rear ? I also would appreciate it if the parts ...
24kkarat said — I had an '03 and it lived 180+ miles in the rust belt. The passenger side is much easier than the driver side. Mine was rusted solid. I tried everything including an air hammer. ...
SWilliams said — First be sure the converter is seated in the pump properly. Then hit a store or junk box and find a longer pair of bolts that you can cut the heads off and thread into the block ...
Slopoke said — I have a 2005 liberty crd. The heater speed control quit working on 1,2 3 only works on high.
jeepisland said — Hello everyone. I am having some weird issues with my 06 3.7 liberty, it's all boiling down to electrical issues I think.... but I am lost trying to figure it out. Past week while ...
MXSST said — Hello all Anyone with any 2007 2.8 CRD KJ Jeep Cherokee immobiliser knowledge ? Battery was allowed to to discharge and go flat, new battery fitted, now when the ignition is switched ...
Bcottrell said — Mr.tommudd i didnt buy the light bar it was a present for a different vehicle i dont have any more and i still want to use it even a smaller one there isnt a good place to mount ... |