Highlighted posts
Ronan_Miller said — From South Africa and got a 2003 KJ recently. I would to make it suitable to camping and what not. Considering putting in a drawer system and roof rack in the future. But I would ...
Jo6pak said — I still want a Scrambler re-introduction. Take the Gladiator and remove the rear two doors, but leave a little space for storage behind the seats. Toss on a 5ft box, make a Willys ...
PocoLoco said — 8 times out of 8 events in 2 months engine will not crank when attempted within 15 minutes after shutdown. Will always start after engine compartment cools for 20 minutes on cooler ...
LabRat said — Okay gang, here's my noobiness shining again... You may remember I have been chasing an intermittent "General Random Missfire" with no other codes for quite some time. I replaced ...
JeepinJarhead03 said — ARBs 1.5" measurement, basically across the board, on springs labeled 1.5" , are AU insurance regulation certed springs , this includes , 2926, 2927, 2790 2947 and 2948 in addition ...
adamo2.8 said — Just bought my first Jeep in years, a 2006 Liberty CRD. Last Jeep was a 1998 Grand Cherokee 5.9 Limited with 8.5 LA lift, 35s, boat sides, etc. What is everyone building for rock ...
2TALL1 said — This is for the rear shocks with 948's Which 5100 series will just bolt up without any different grommets or washers, spacers, Ect.........?? My head is spinning from so many different ...
bladerunner555 said — Has any one had to cut out the sections in front bumper where tow hooks might be,in order to put on a grill guard? [link]
maynard said — Hi all! New to the forum here and not real familiar with Jeeps... My father can no longer drive and has a 2005 Jeep Liberty Limited with 78k miles on it. I am thinking about purchasing ...
s33d5 said — Hey, On my 04 liberty I am gonna pull out the front seats later, and have a go at the metal on the side with a dremel to see if I can get it to lay flat (there's probably just ... |